Aqua-Hot Gen1 Air/Water Heater
$21.99
The Gen1 from Aqua-Hot is a direct replacement for the Truma Combi.It’s multi-purpose appliance designed to save space and weight in a vehicle while still providing the highest level of climate comfort as well as 2.64 G of hot water.The Aqua-Hot Gen1 can heat water independently of the furnace, keeping…
The Gen1 from Aqua-Hot is a direct replacement for the Truma Combi.
It’s multi-purpose appliance designed to save space and weight in a vehicle while still providing the highest level of climate comfort as well as 2.64 G of hot water.
The Aqua-Hot Gen1 can heat water independently of the furnace, keeping owners comfortable year-round and ensuring they’re always ready for a luxurious hot shower from anywhere on the road. Warm air flows into the coach’s interior through 4 air outlets where it is distributed evenly and efficiently for a consistently comfortable internal temperature.
The Aqua-Hot Gen1 is rated for high altitude operation up to 15,000 feet above sea level – compared to competitive models that are only rated up to 4,000 feet.
Gen1 uses RV-C Open-Source intelligence for user-friendly control and easy integration into your application.
A Heating and Hot Water Heater System
- – All-in-one heater – combines both air and water heating in one compact unit
- – High altitude rated and auto adjusting up to 15,000 ft
- – No Anode Design – no maintenance
- – Easy-to-use Controls – LCD control screen is intuitive and adaptable
- – Automated Timer
- – 4 Heating Fan Speeds – balanced distribution of warm air
- – 10 Air Circulation Fan Speeds
- – Open Source/ RVC ready
- – Three fuel options – can be powered by propane, gas, or diesel
- – Shore power heating – when available, use shore power to heat so you can save on fuel
- – Complete installation kit – includes everything needed for a typical application
- – Made in the USA – Colorado
- – Two-year limited warranty – must be installed by a certified shop. Contact us to coordinate your install with a RackUp+Go partner in your area.
|
|
Gen1 Propane |
Gen1 Gas |
Gen1 Diesel |
|
Hot Water Capacity |
2.64 G stainless steel tank |
2.64 G stainless steel tank |
2.64 G stainless steel tank |
|
Time to Heat the Water Tank |
20 Minutes |
20 Minutes |
20 Minutes |
|
Fuel Type |
Propane |
Gasoline |
Diesel |
|
Heating Output |
20,000 BTU/hr |
13,500 BTU/hr |
13,500 BTU/hr |
|
Heat Output on Electric |
6,000 BTU/hr |
6,000 BTU/hr |
6,000 BTU/hr |
|
Fuel Consumption (maximum) |
.35 to 1.05 lb/hr |
.19 gal/hr |
.16 gal/hr |
|
Power Supply |
12 V DC – 110 V AC |
12 V DC – 110 V AC |
12 V DC – 110 V AC |
|
Current Draw (maximum) |
15.6 A |
15.6 A |
15.6 A |
|
Dimensions (L x W x H) |
20.1″ x 17.7″ x 11.8″ |
20.1″ x 17.7″ x 11.8″ |
20.1″ x 17.7″ x 11.8″ |
|
Weight (Without Water) |
34.4 lbs |
34.4 lbs |
34.4 lbs |
|
Air Flow Rate |
169 CFM |
169 CFM |
169 CFM |
|
Altitude Operating Range |
Up to 15,000 ft |
Up to 15,000 ft |
Up to 15,000 ft |
Downloads
- Data Sheet
- Owner’s Manual – Propane
- Owner’s Manual – Gasoline
- Owner’s Manual – Diesel
- Installation Manual – Propane
- Installation Manual – Gasoline
- Installation Manual – Diesel
Included in this kit:
- Heater w/ electric heating element
- 12V DC power cable
- Control panel w/ wiring
- Terminals/connectors
- Room temperature sensor (thermistor)
- Air intake/exhaust
- Air intake/exhaust port and sealing gasket
- Air intake/exhaust mounting clip
- C-clip and clamp for exhaust tubing
- Air duct mounting brackets
- Fixed louver/vents for heated air
- Adjustable louver/vents for heated air
- Fuel pump assembly
- Push-to-connect fittings (10mm OD 1/2″ BSPP)
- 1/2″ PEX x 1/2″ NPT male (brass)
- 1/2″ PEX x 1/2″ NPT female (brass)
- Water check valve
- 40 PSI water pressure regulator
- Fuel standpipe/pickup
- 4.1mm ID fuel line couplers
- 3.5 ID fuel line couplers
- Fuel line check valve
- Fuel pump mount
- 9-11mm fuel line clamps
- 8-10mm fuel line clamps
- 70-90mm work drive clamps
- Air distribution cap
- 7.89mm SAE – 4mm fuel line elbow
- Exhaust vent
- Control knob
- 4 meter (13′) lengths of heated air ducting
- 6.8 meters (22′) clear fuel line hose (2mm ID, 4MM OD) (pump to system)
- 1.2 meters (3.9′) blue fuel line hose (1.5mm ID, 5mm OD) (fuel tank to pump)
- Fuel pump wiring – 6.8 meters (22′)
- Various misc. fasteners
Reviews
There are no reviews yet.